Unevenness and hollow spots under the finish
Hollow sounds or soft spots point to missing adhesion or an uneven subfloor. Making good then usually means: finish out, lay again.
Tiles, parquet & joints: the expensive finish is open
Now the actual floor finish is going in — parquet, tiles, vinyl or carpet. Faults in joints, falls or fits only really show once the skirting is on. Document systematically while corrections are still possible.
The most common expensive defects in floor finishes and joints
Open joints, wrong widths or missing elastic connections
At walls, door thresholds and wet zones, joints decide tightness and appearance. Missing elastic connections become expensive extras later.
Damaged or badly cut finishes
Scratches, chips and poor cuts at corners and door frames are often disputed after handover.
Skirting and transitions untidy
Gaps, uneven skirting boards and missing transition profiles are typical complaints at move-in.
What to check and photograph now
Photograph each room as an overview
Photograph each room from two angles. This captures the laying pattern and the overall impression.
Photograph critical spots close up and tap them
Tap the surface and photograph corners, thresholds, niches and visible unevenness from close up.
Note open defects with room and finish type
Create a short list of defects. Always note the room and the finish type, this helps with making good.
Check edge joints to the wall
Check all around if a gap remains between the finish and the wall. If the finish touches the wall, it will buckle later.
Secure finish and joints now
Upload your photos and name the room and finish type. We help to classify what is still missing on the finish and joints.